Skip to main content
F3D
Nâng cấp Linear Rail trục X cho Elegoo Neptune 3 Plus… 1

5 images

Máy In 3D

Nâng cấp Linear Rail trục X cho Elegoo Neptune 3 Plus (MGN9H 400mm)

By Barravox

Downloads
55
Likes
4
Views
462
Remixes
1

Files 2 161 KB

  • Extruder_Back_PlateAdapter_El_NE3Plus_1777671789.3mf3MF · 49.5 KB
  • Linear_Rail_x_Neptune_3Plus_1777671790.3mf3MF · 111.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#360545
Category
Máy In 3D
Published

Description

This model is recommended to be printed in PETG or ABS and can be printed on the Elegoo Neptune 3 plus bed by positioning the rail mount at a 45 degree angle on the bed. 

Print Settings(For either ABS or PETG):

  • 4 top and bottom layers
  • 3 walls
  • 35%-45% infill (Gyroid Recommended) 
  • Supports are not needed

You will need to pause the rail mount print to insert the M3 Hex Nuts (x20) into the rail mount.(This also can be modified so that heat inserts can be used)

After printing you can use x20 M3x8 Socket Head Cap Screws to secure the rail to the rail bracket. To connect to the printer, remove the original print head, and the black screws on the back of the x-axis. Note: the crush washers will need to be removed, but the screws themselves can be reused to secure the bracket to the x-axis extrusion. 

For the rail adapter(which attaches the print head to the rail carriage) can be printed with the settings shown before, and can be attached to the backplate of the extruder with the original screws used for the BOM wheels(For the top holes only the screws will need to be installed as shown in the picture for successful, the bottom screws can be installed as they were with the BOM wheels). 

NOTE: All wheels used previously to mount the extruder to the x-axis will NOT be reused in this mounting set up and the screws will be used to mount the extruder to the adapter bracket. 

POST UPGRADE NOTES:

  • Relevel your print bed and redefine your z-offset
  • Recommended: use some form of z-lift for your prints so as to not knock it off the build plate (I use 0.25 mm lift for most prints)

Total required materials:

x24 M3-8 SHCS

x20 M3 Hex Nuts

50-75 grams of filament

Any and all comments, changes, or independent improvements are welcome and encouraged. I only ask that the modifications are reposted for the use of others.

Read more Show less

Print spec

Formats
3mf
Model files
2
Total size
161 KB
Largest file
111.5 KB

0 comments

See all