RatRig V_Minion V1 lên V1.1 - Mod Umbilical Toolhead

A new print head for V-Minion V1 which is originally intended for the RatRig V-Core 3.1 and V-Core 4.0. It's smaller and lighter than the one with Eva. Now it's also available for the RatRig V-Minion V1. This mod uses the MGN12C 250mm carriage and the M3x4.6x4 heat inserts suggested by RatRig and the screws listed in the original RatRig BOM. These can also be purchased at a local hardware store and can painted black. The M3x52 and M3x35 countersunk screws used here were originally Mx60mm. I shortened them by hand.

Print Setting:  - 4 Walls @ 0.45mm, 35% Infill and minimum Pet Filament