Skip to main content
F3D
Fish Feeder (Bộ cho cá ăn tự động) 1

27 images

DIY

Fish Feeder (Bộ cho cá ăn tự động)

By swemaker

Downloads
7
Likes
1
Views
202

Files 13 4 MB

  • Electriccentral2_1777653466.stlSTL · 596.1 KB
  • Electric-Lid2_1777653467.stlSTL · 79.2 KB
  • Food-Box_1777653468.stlSTL · 879.6 KB
  • DC-Motor_Gear_1777653469.stlSTL · 304.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a automatic fish feeder made with 3d printing and some electronic parts.

Print with what you like, I did use PETG and PLA

0,2 mm height

nozzle 0,4 mm

10% infill-Gyroid

3 walls

5 bottom

5 top

You need to use support on the “Axle-holder” and “Food-box”, may need even on the “Electriccentral” if you have bad bridging.

You need some CA glue and 1 M5x20 insex bolt, 12 magnets 4x2mm, 1 POM-wheel bearing like ender3 style. The relayholder was hard to make slots that was tight because the different relay maker cut the PCB in different size. So you are supposed to glue the relay to the relayholder. 

Begin with soldering the cables as I have in the pic with the switch and DC motor and the Arduino, and dont forget to upload the code to the Arduino board.

Electronics parts needed:

1 Arduino Nano

1 Microswitch

1 12V DC powersupply with 2.1mm connertors

1 Relay KY-019

1 DC motor JGY-N20 16RPM

Arduino code for arduino IDE:

// C++ code

//

int relayIn = 2;

void setup()

{

  pinMode(relayIn, OUTPUT);

  Serial.begin(9600);

}

void loop()

{

    digitalWrite(relayIn, HIGH);

    delay(4000); // Wait for 4000 millisecond(s)

    digitalWrite(relayIn, LOW);

    delay(1000*86400-4000); // Wait for 24hrs 1000*86400-4000

}

Read more Show less

Print spec

Formats
stl
Model files
13
Total size
4 MB
Largest file
886.4 KB

0 comments

See all