Giá gắn phụ kiện KitchenAid nam châm - Tham số (Parametric)

This model is a remix of https://www.thingiverse.com/thing:4340836 which itself is a remix of https://www.thingiverse.com/thing:3252061.

This is a mount for KitchenAid stand mixer accessories which is intended to have an embedded magnet, in order to allow you to attach it to the underside of a magnetic surface--in my case, my microwave.

This model has some parametric variables in case you have a different size or strength magnet and want to adjust. The model as designed fits these magnets from McMaster Carr: https://www.mcmaster.com/5862K111/

My model has been measured and created from scratch and does not actually use any measurements from the originals from which it draws inspiration.

Feel free to Buy Me a Coffee if you like what I've done.

Print instructions

My Slicer project configuration is included as a download for reference, but I printed as follows:
Supports:
Yes - Strongly recommended on obvious overhang

Resolution:
0.2mm

Infill:
5-10%

Filament_material:
Doesn't matter too much. PETG might be better but I used PLA as these don't hold a lot of weight

Notes:
My print project is included to illustrate where I added supports, and it also includes a pause at 6mm in order to allow for embedding of the magnet.