
Afterbearner – Prusa Bear Afterburner (StealthBearner hiện tại)
- Downloads
- 1,578
- Likes
- 256
- Views
- 15,496
- Remixes
- 1
- Comments
- 0
Files 29 35.1 MB
- ChainFixtureFrame_1777647153.stlSTL · 155.9 KB
- ChainFixtureBedV2_1777647154.stlSTL · 392.4 KB
- heatbed_terminals_cover_repaired_1777647155.stlSTL · 117.2 KB
- 2x2_Y_Moto_v2_p1_1777647156.stlSTL · 211.6 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #358513
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v3.0
Description
Extra motor to compensate for bed wight using de Z driver slot and sending more current, files in folder Dual Y motors upgrade, careful my printer its longer in Y than the normal size, that's how I can fit more stuff. The parts are mirrored from the one in the video so you don't have to swap cables on the new motor to reverse it.
Update: Video printing @ 350mm/s
UPDATE - added Nozzle Endstop, it works with allen bit, It might need adjusting or remodeling for other allen bit pocket, uploaded step in case you need to modify.
UPDATE - Added x-carriage for the new stealthbearner and moded cable lid (if you want the upgrade but don't want to mount a new carriage you can drill the 2 top holes with a 4 mm drill bit 4mm deep and place two threaded inserts (it worked for me on two machines do it at your own risk).
UPDATE - Added a new cable cove to keep the connectors on top of the extruder to get more x axis travel to add a z-endstop similar to what is used on the Voron 2.4 and a new part to use the same filament sensor as the mk3 with reverse bowden, a spool holder. IT ONLY WORKS WITH THE BEAR UPGRADE as its held to the the side extrusions.
Update V2, made tha strain relief stronger it was a bit to flimsy (beltlid and cable guide V2)
Mod for fitting and Voron Afterburner extruder on a Prusa i3 Mk3 and newer.
Remixed from the Voron Design Legacy X carriage and The BearExxa Bear upgrade.
Had to bring the linear rods together 5 mm to be compatible with the Legacy x carriage so yo have to redo the x axis assembly.
It uses heat inserts and m3x40, m3x35, m3x30 and m3x25 screws plus all hardware for the Voron Afterburner.
I just built it and haven't configured any firmware yet
Added step files.
Fusion360 file at https://www.thingiverse.com/thing:4742758
Voron Design Afterburner Github: https://github.com/VoronDesign/Voron-Afterburner
Bear Upgrade x axis: https://github.com/gregsaun/bear_extruder_and_x_axis
Print instructions
print with 20% to 25%
Five top and bottom layers
4 perimeters
no support needed
Print spec
- Formats
- stepstltxt
- Model files
- 29
- Total size
- 35.1 MB
- Largest file
- 19.2 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-
New -
New -

-

-



