Skip to main content
F3D
Hộp Đựng Ống Kính Vision Pro (Vision Pro Lens Case) 1

6 images

Dụng Cụ Tiện Ích

Hộp Đựng Ống Kính Vision Pro (Vision Pro Lens Case)

By 3d_printNerd_4043851

Downloads
188
Likes
19
Views
1,512

Files 7 2.8 MB

  • Top_with_text_1777633617.stlSTL · 675.5 KB
  • Vision_Pro_Text_1777633618.stlSTL · 623.8 KB
  • Lenses_Text_1777633619.stlSTL · 475.2 KB
  • Top_-_no_text_1777633620.stlSTL · 447.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Apple recommends removing the lenses from the Vision Pro during travel. You also need to remove them when allowing others to use it. This case is to help keep them safe.

Parts needed

  1. Case top (multi-material optional)
  2. Case bottom
  3. 2 copies of endplug (optional)
  4. 4 copies of O-ring
  5. Metal rod  - 100 mm x 2.2 mm (or a 100 mm piece of filament)
  6. 4 cylinder magnets - 10mm x 3mm

Assembly

  1. Print the top and bottom case halves, using multilateral if desired to get the text on the top. End caps can be printed at the same time if desired (not required)
     
  2. Print 4 copies of the O-ring in TPU.  I recommend either 0 top and bottom layers, 15% hex infill, or 1 top and bottom layer, 5% 3D hex infill
     
  3. Assemble as shown. Rod should be approx 2mm in diameter, I cut a piece from a wire coat hanger. If you don't use the endcaps, slightly bow the rod for retention.  (You can use a piece of filament instead of the metal rod. It's a little bit looser, but not bad) Press fit in the magnets, making sure to align the polarities appropriately so the case will stay shut.  Press fit in the O-rings.

If you can't print TPU, I recommend cutting some insulation or shipping foam to approximate the O-rings

Read more Show less

Print spec

Formats
stl
Model files
7
Total size
2.8 MB
Largest file
675.5 KB

0 comments

See all