Skip to main content
F3D
Ốp TPU bảo vệ cho remote Fire TV Stick 1

3 images

Dụng Cụ Tiện Ích

Ốp TPU bảo vệ cho remote Fire TV Stick

By Vinors3DLab

Downloads
116
Likes
12
Views
522

Files 1 178.9 KB

  • coverfirestick_1777607445.stlSTL · 178.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Give your Fire TV Stick remote a grippy, shock‑absorbing armor with this custom TPU cover, designed specifically for flexible filament printing. The model is optimized for everyday use: easy to slip on, snug once in place, and protective without adding unnecessary bulk.

Features

  • Tailored fit: Designed around the Fire TV Stick remote shape for a tight, rattle‑free fit.

  • Shock absorption: TPU acts as a soft bumper, helping protect the remote from drops and impacts.

  • Improved grip: Slightly textured surfaces and flexible material make the remote easier to hold, especially with dry or sweaty hands.

  • Full button access: All buttons, microphone, and IR/emitter areas remain accessible—no interference with normal use.

  • Raised edge protection: Slightly raised front lip helps protect the remote if it lands face‑down.

  • Lanyard/strap option (if present in your model): Small hole/loop at the bottom for attaching a wrist strap or keyring.

Printing recommendations

  • Material: TPU (Shore 95A or similar). Softer TPUs also work but may feel looser.

  • Layer height: 0.2 mm is a good balance between detail and print time.

  • Perimeters: 3 walls for strength and elasticity.

  • Infill: 15–25% (gyroid, grid, or cubic). Most of the strength comes from the walls.

  • Top/bottom layers: 4–5 layers.

  • Print orientation: Print the cover standing upright or on its back, depending on your slicer preview and bed adhesion. Choose the orientation that gives you clean inner walls and a smooth outer surface.

  • Supports: Usually not required if your printer handles moderate overhangs. Enable minimal supports only if your slicer shows problematic areas.

  • Speed: Reduce speed for TPU:

    • Walls: ~20–30 mm/s

    • Infill: ~30–40 mm/s

  • Cooling: Low to moderate part cooling (too much can reduce layer adhesion in TPU).

Fit and usage notes

  • Test fit gently: After printing, flex the cover slightly and slide the remote in from the bottom. TPU will stretch a bit and then hug the remote.

  • If the fit is too tight or too loose:

    • Too tight → scale the model to 101–102%.

    • Too loose → scale down slightly to 98–99%. Small scaling changes in TPU make a noticeable difference.

  • Cleaning: TPU can be wiped with a damp cloth. Avoid strong solvents.

Compatibility

  • Designed for: Amazon Fire TV Stick remote (specify generation here if needed, e.g. “3rd gen Alexa Voice Remote”).

If you notice a mismatch with a specific Fire TV remote version, let me know in the comments and I can adjust or upload a variant.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
178.9 KB
Largest file
178.9 KB

0 comments

See all