
Kẹp Filament (Filament Clip)
- Downloads
- 122
- Likes
- 13
- Views
- 413
- Remixes
- 0
- Comments
- 0
Files 1 80.1 KB
- Filament_Clip_1777606752.stlSTL · 80.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #357163
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
There are many good clips out there. I have downloaded several clips and tried them. The side clip either hard to push in or just break off. Others I had to swoop under the filament just to clip two rounds into the clip, which after time gets loose from wear and not hold. Mine just has a hole for 1.75mm filament on either side. It only holds due to having a length of filament through the hole. It fits loosely on a 1mm spool rim, clips over a larger rim, works well on a 5mm cardboard spool. You may need to clean out the holes on the bed printed side due to swish. I used generic PLA, 0.20 layer, 2 walls (3 walls stronger). Small part, raft recommended.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 80.1 KB
- Largest file
- 80.1 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-
New -

-

-

-

-

-

-


