Búa Gavel

This is a little chunky, more for fun use cases. Mind the tolerance for the hole when inserting the handle, it is a very tight fit and may need minimal sanding. My fix for this issue is to lower the speed on walls to make sure it fits. The supports used to print the head of the gavel in the pre-setted direction in the cura file will need supports. Because of the residual supports the handle can be jammed in while it acts as an improvised adhesive/suction. Also there is wings on the handle so it doesn't spin. 

Cura settings guide

I printed with a 0.6mm nozzle (you don't have to)

“average printer speed”

Body - 15% infill

Supports - 15% infill

Thanks for printing!