
Chốt Canh Đăng Ký In Khắc (Printmaking Registration Pins)
- Downloads
- 766
- Likes
- 49
- Views
- 2,618
- Remixes
- 0
- Comments
- 0
Files 3 144.2 KB
- Registration_Tabs_and_Pins_1777587318.scadSCAD · 1.4 KB
- Registration_Tabs_1777587319.stlSTL · 61.1 KB
- Registration_Pins_1777587320.stlSTL · 81.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #356378
- Category
- Mỹ Thuật
- Published
- License
- Creative Commons — Attribution
- Tags
Description
Pins and Tabs used for registration of multi-color relief prints.
Print at least two Pins and then as many tabs as you need to do a print run.
When printed the tabs should fit tight into the pins. This is by design. Depending on your printer the tolerance may or may not make a good fit. I print the tabs and then if they are too tight I just give them a very small swipe inside the hole with an X-ACTO blade.
Once shaved down the tab should fit the pins slightly tightly but not too tightly, and not too loosely obviously. Welcome to 3D Printing!
Note: These are very thin prints! I printed mine at 0.1 layer height.
The tabs use about $0.01 worth of plastic, so if you ruin one trying to shave it down to a perfect fit it's no big loss.
The OpenSCAD file is included if you want to make any changes.
More Info: https://rasterweb.net/raster/2024/02/18/printmaking-registration-pins/
Print spec
- Formats
- scadstl
- Model files
- 3
- Total size
- 144.2 KB
- Largest file
- 81.6 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-
New -

-

-

-

-

-
New

