Bánh xe Robomow bên phải - SPP7021A

Hi,

the wheel was created to give the mower "Robomow MC / RS / MS / TS / RC" a better grip and a cool look.

----------------------------------------------------------------------------------------------------------
It was pointed out to me by @Klaus_1438843 that the diameter is slightly smaller than the original.
I was aware of this, but it should be mentioned for you. Thank you Klaus_1438843 .

It does improve the torque, but changes the grip. (Presumably, however, the other profile in turn improves the grip so it won't matter)

So before you waste material, weigh it up and decide whether you want to print it :-)
----------------------------------------------------------------------------------------------------------

Replaced the original Robomow wheel SPP7021A.

The two extra holes would be for an aditional hubcap.

• Looks like a tractor tyre with airless design.

Please note:

• use a weather proof material
• usa a UV stable material
• for the left side download the other model

have fun with my 3D model

if you want to keep me awake, feel free to buy me a coffee ;-) https://paypal.me/saiboTTech

-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-

If you have any suggestions / Ideas for the design, please do not hesitate to send

them to me under the comments.

Print Settings

Printer:

Alfawise U20 Pro

Rafts: 

Doesn't Matter

Supports:

Yes

Resolution: 

0,2

Infill:

20%

Filament:

what you want no particular PETG or TPU Sh90

what you want

Notes:

The other part is Thing no: 3786498
https://www.thingiverse.com/thing:3786498

The wheel lock is Thing no: 3806963 

The hubcap is Thing no: 3820378 https://www.thingiverse.com/thing:3820378

+++++++++++++++++++++++++++++++++++++++

I have created a new STL file with supports.

This allows printing without a slicing support.

After printing, these can be removed very easily.

Category: Outdoor & Garden