Bàn Cờ Steampunk (Steampunk Chess Board)

This is not a full set of STL files.  This is just a few 3MF files that you can open with Prusa Slicer.  I have taken the Chess Board created by @byWulf and added a modifier that I made using @Adioliquid's Gears squares.  If you do not have Prusa Slicer then I don't think any of these files will work for you except for the gear stl.  

If you do use Prusa Slicer then all you have to do is:

• Open the 3mf files as a project.
• Change the printer, print profile and filament settings to use your own.
• Change the filament colors for each extruder to match your setup.
• Change the view to look at the bottom of the print.
• Assign the color/extruder you want to each piece/modifier.

Follow the assembly and BOM instructions found on the Chess Board page.

This took me a couple hours to get setup and I liked the results.  So, I figured I would share it with the rest of you.  Enjoy.