Bàn cờ Tak (Tak Board Game)

Tak board carries 60 pieces for playing 6x6 games. The case isn't perfect when closing the case back together but it is good enough. 3mm X 8mm magnets were used for this build. A little super glue before firmly pressing the magnet in will work great. My goal was to make a 6x6 board but taking up the smallest footprint while holding all the pieces to play the game held inside. 

I did buy a wooden piece set off of this site. I'm sure you could print your own. I can probably make those if people had enough interest. 

My version seen in the photos was printed with wood infused filament to give it that tan wood look. I also used a brown marker to fill in the recessed lines to give it a nice touch. I printed the model with the top of the board faced down (slots are facing the air). 

Happy printing!

Caution: Don't put board in the sun and in a warm location for it probably will warp. My first print warped after being in a warm car.