Skip to main content
F3D
Khớp nối lồng đỡ cà chua cho ống PVC 1

3 images

Đồ Gia Dụng

Khớp nối lồng đỡ cà chua cho ống PVC

By JohnS

Downloads
170
Likes
47
Views
1,357

Files 12 3.5 MB

  • 4_sided_fitting_1_5V_1_0H_1777544791.stepSTEP · 89.9 KB
  • 4_sided_fitting_1_5V_1_0H_1777544792.f3dF3D · 164.9 KB
  • 3_sided_fitting_1_5V_1_0H_1777544793.stepSTEP · 116.4 KB
  • 3_sided_fitting_1_5V_1_0H_1777544794.f3dF3D · 240.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#354779
Category
Đồ Gia Dụng
Published

Description

Models should load in correct orientation to print without supports.  

I used PETG. You will want to print with as little cooling as possible for stronger layers as these are put under a lot of stress. I have been using these for 3 years already and have only had a couple fittings break. 

I give you a few options here.

  1. Personally, I recommend using the one labeled “3 sided fitting 1_5V 1_0H”.  This makes a 3-sided cage and uses 1.5" diameter PVC pipe for vertical posts and 1" for the horizontal members.  This is the best balance of strength and cost in my opinion.
  2. There is also a “3 sided fitting 1_0V 1_0H and this is the same but uses 1” for verticals, but the result is a way too wobbly in the legs unless you use something stronger than pvc. 1" PVC posts may be just fine on smaller frames. Mine were 4 foot tall.
  3. The other option is “4 sided fitting 1_5V 1_0H”.  This makes a 4-sided cage but does require that half the fittings are “4 sided fitting 1_5V 1_0H_w diag” which includes provisions for a diagonal member to hold the frame square.

I used wood screws to secure the pipes in the fittings. Drill pilot holes slightly smaller than the screws.

I use t posts to anchor these down. Mostly old broken in half ones. To keep wind from tipping them over, I anchor at least 2 corners.

 I included step and Fusion 360 files so you can modify as needed.

Read more Show less

Print spec

Formats
f3dstepstl
Model files
12
Total size
3.5 MB
Largest file
619.2 KB

0 comments

See all