
MiniSkidi Mk3 bản Radio Control kèm FPV
Remix of Mô hình RC SkidSteer V3.0 In 3D By ProfJohnny_823077
- Downloads
- 255
- Likes
- 49
- Views
- 1,490
- Remixes
- 0
- Comments
- 0
Files 18 2.6 MB
- My_Forks_-_Smaller_1777496508.stlSTL · 31.9 KB
- Right_Arm_Wire_Cover_1777496508.stlSTL · 45.8 KB
- FPV_Mount_1777496509.stlSTL · 100.1 KB
- 4-Left_Arm_for_Servo_1777496510.stlSTL · 132.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #353006
- Category
- DIY
- Published
Description
There is a PDF file giving the parts I used and some build notes. The OpenTx transmitter files and “sounds” are also included in a ZIP file.
This is quite a challenging build due to its small size but great fun to operate. Only the parts I modified are included in the STL files. For all the other parts use the original Professor Boots files.
The main parts I changed are:
Main Housing - modified to “locate” the track motor speed controller and RC switches, and to attach a servo to operate the Left Arm instead of the N20 motor.
Left Arm - to attach to the servo.
Right Arm - to incorporate the changes I made for a quick release “Claw” wiring connector (see another of my "Remixes").
Axles and Wheels - to free up space inside the MiniSkidi and to make the Wheel / Axle interface easier to print.
Driver Cage - Visual improvements, different Leds and cable ducts, plus slots in the roof for the FPV camera to see through when the arms are raised.
Fork Lift attachment - made smaller to look more in “scale”.
New Part - “Floor” which holds down the two track drive motors (replaces the original motor clamps) and also locates / attaches the radio control receiver, FPV system, and LiPo.
New Parts for the FPV camera and its “tilt” servo system.
Print spec
- Formats
- pdfstlzip
- Model files
- 18
- Total size
- 2.6 MB
- Largest file
- 426.1 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-
New -
New -

-

-


