
DIY
Bộ Hút Khói Hàn (Solder Fume Extractor)
- Downloads
- 117
- Likes
- 53
- Views
- 1,824
- Remixes
- 0
- Comments
- 0
Files 5 1.2 MB
- fumeExtractorBase_1777408489.3mf3MF · 196.4 KB
- fumeExtractorGrill_1777408490.3mf3MF · 91.5 KB
- fumeExtractorGrill_1777408491.stlSTL · 36.4 KB
- fumeExtractorBase_1777408492.stlSTL · 318.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #349641
- Category
- DIY
- Published
Description
Check out the build video on YouTube! https://www.youtube.com/shorts/HjpijkvjOJA
Prints without supports; I used PETG. Built with parts I had on hand, here are links for your convenience:
- 120 mm fan (I used a Noctua NF-P12, but any should do): https://www.amazon.com/gp/product/B07CG2PGVG
- Panel mount barrel jacks (2.1 mm): https://www.amazon.com/dp/B091PS6XQ4
- 3-pin screw terminals: https://www.amazon.com/gp/product/B07RLJQWNZ
- 2-pin screw terminals: https://www.amazon.com/gp/product/B07NSJV6NW
- Perfboard: https://www.amazon.com/gp/product/B079DN31SW
- Nuts/bolts (M4, M2): https://www.amazon.com/gp/product/B07S1R8NL7
- Don't use the specific LED strips I used, they have a terrible CRI! Anything 12V should work, just cut to fit. The LED track is 10 mm wide.
Note the LED wiring can block the lower bolt holes, so you'll either need to move the wires to the side to fit a bolt through, and/or get a bit creative with the assembly order.
Print spec
- Formats
- 3mfstepstl
- Model files
- 5
- Total size
- 1.2 MB
- Largest file
- 571.8 KB
0 comments
You may also like 12 models
See all-
New -
New -

-

-

-

-
New -

-

-
New -

-


