
Kẹp dây đai GT2 (GT2 Belt Clamps)
- Downloads
- 105
- Likes
- 16
- Views
- 740
- Remixes
- 0
- Comments
- 0
Files 4 228.7 KB
- 6mm_Belt_clip_pt_2_1777349980.stlSTL · 3 KB
- 6mm_Belt_clip_pt_1_1777349981.stlSTL · 118.9 KB
- 10mm_Belt_Clasp_pt2_v_3_1777349982.stlSTL · 3 KB
- 10mm_Belt_Clasp_pt1_v_3_1777349983.stlSTL · 103.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #347410
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
- Tags
Description
As I was trying to come up with a method to secure my timing belts to a laser build I am working on. I came up with these belt clips. There were a few qualities I wanted to achieve with the clips 1. They had to be small and not add a much bulk to the belts, 2. they had to clamp the belts securely to the carriages 3. they had to look sleek, like a manufactured part. I used ESun PLA filament and found that the layer adhesion was quite a bit better then the Creality filament and even ran the machine 10 degrees C lower at 205 nozzle temp. I print with an Ender 3 pro and a sprite extruder with a .4 nozzle using Cura as my slicer. I will admit that my laser is not completed and the drives are not functioning at the moment so I have not fully tested them, but they survived a pull test and once together are difficult to pull apart. If you print these and have any suggestions I would like to hear them. Thanks
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 228.7 KB
- Largest file
- 118.9 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-
New -


