Trứng Phục Sinh gắn Tealight (Easter Egg with Tealight)

Remixed the Original to fit an electrical Tealight right from the get go

the hole is 38mm in diameter. This fits a normal and an electrical tea light.

I recommend a brim and Support at least for the inner top part, because the overhamgs are a bit extreme there.

I used a lot of Support for a Clean Finish Look at the Pictures.

You can just print the Scaled up Version (which is huge) or use the smaller version which just cuts off something from the bottom and enlarges the hole to fit the tealight. (You can also do that with the original of course, just head over yourself.

Thanks to the original creator