Skip to main content
F3D
Voron 2.4R2 - Bộ vệ sinh nozzle & Purge Bucket 1

1 image

Máy In 3D

Voron 2.4R2 - Bộ vệ sinh nozzle & Purge Bucket

Remix of Ống chà đầu phun kèm thùng nhỏ cho Voron 2.4 By FunFunBoy

By jmillerfo_84104

Downloads
643
Likes
114
Views
8,921
Remixes
1

Files 2 178.1 KB

  • Brush_Holder_1777303737.stlSTL · 117.2 KB
  • Bucket_1777303738.stlSTL · 60.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

This is a remix of the referenced Nozzle Scrubber by FunFunBoy.   This version changes the magnets to 10mm and increases the count to 3 on each of the Bucket and Holder parts.  Minor changes were made to the brush holder to accommodate brushes sourced from Amazon.

Trim the Brush Head as required to fit into the mount with a slight interference fit.  Insert the trimmed brush head into the mount and fasten the mount to the RH print bed rail 1mm from the aft side of the milled print bed.

The following Klipper macro can be used to clean the print nozzle on command or imbedded in other gcode such as PRINT_START.  The code assumes a 350x350 print bed.  Adjust the settings to match your configuration.

#####################################################################
# Nozzle Clean and Purge Bucket
#####################################################################
[gcode_macro CLEAN_NOZZLE]
variable_start_x: 315
variable_start_y: 356
variable_start_z: 7.5
variable_wipe_dist: -50
variable_wipe_qty: 5
variable_wipe_spd: 200
variable_raise_distance: 20

gcode:
{% if "xyz" not in printer.toolhead.homed_axes %}
G28
{% endif %}

G90 ; absolute positioning
## Move nozzle to start position
G1 X{start_x} Y{start_y} F6000
G1 Z{start_z} F1500

## Wipe nozzle
{% for wipes in range(1, (wipe_qty + 1)) %}
G1 X{start_x + wipe_dist} F{wipe_spd * 60}
G1 X{start_x} F{wipe_spd * 60}
{% endfor %}

## Raise nozzle
G1 Z{raise_distance}

BOM

QTY

P/N

Description

Link

1

Brush

Brass Brush

https://www.amazon.com/gp/product/B06XWFM1HJ

2

M3x8

Cap Screws

2

M3

T-Nuts

https://www.amazon.com/Hulless-Sliding-Fastener-Aluminum-Accessories/dp/B08NZMD2BJ

6

10x2mm

Magnets

https://www.amazon.com/gp/product/B092MB697H

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
178.1 KB
Largest file
117.2 KB

0 comments

See all