
Kẹp Dây Belt Tốt Hơn cho The 100
Remix of Kẹp Dây Đai Cho The 100 By AndrewG_1109527
- Downloads
- 300
- Likes
- 30
- Views
- 1,176
- Remixes
- 0
- Comments
- 0
Files 6 592.5 KB
- belt_clamp_toothed_side_v2_1777257923.stlSTL · 103.5 KB
- belt_clamp_flat_side_v2_1777257924.stlSTL · 44.8 KB
- belt_clamp_v2_1777257925.stpSTP · 152 KB
- belt_clamp_1777257926.stpSTP · 145.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #343665
- Category
- Máy In 3D
- Published
Description
The original did not mesh with the GT2 profile causing it to need to apply pressure to the belt and bow out, eventually failing. This redesign uses an accurate GT2 profile to hold the belt without the need for clamping force.
Additionally, now the screws screw into plastic instead of using nuts. Do not overtighten! The clamps do not hold the belt by squeezing it. Instead the belts are held by the interlocking with the teeth. In fact you may be able to slide the belt side to side in the clamp. This is expected.
I tested these with a 9 min 20 second benchy print and they held up.
Hardware
- 4 M3 x 6mm screws, preferably button head for weight ;)
Print Instructions
Print with the teeth facing up. See photos for print orientation example.
- 100% infill
- 4 walls
- 0.4mm line width
- 0.12 layer height
Changelog
- v2: Reduced length and thickness to reduce weight and changed recommendation from 10mm to 6mm screws.
Print spec
- Formats
- stlstp
- Model files
- 6
- Total size
- 592.5 KB
- Largest file
- 152 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-
New -

-

-

-

-


