Nắp chai / Kronkorken (TPU)

There are 2 versions of the bottle cap. V2 is a little more solid and grips better than V1. V2 MIGHT be a little too tight for small kids…but that also depends on your choice of material. 

Material used:

Filatech FilaFlexible40, blue (prints well, no stringing with Prusa-Profile) and

Recreus Filaflex 82A, orange (lots of stringing when moving from part to part…i didnt completely master the Recreus yet. No problem when printing only one at a time.) for the bottom part of the model

Fillamentum Flexfill 98A for the upper part…for haptic reason. It feels sooo good to plop the cap on your bottle :) (should be harder material than the one used for the lower part, i think a 98A is the best solution and prints pretty well…maybe use 95A, if you got that.)

You can also print it with just 1 filament, but like I said above…haptic reasons.

I you don't know how to do a filament change, you should learn it :) …or check out the .3mf i added.

have fun with it.