
Blobfish DLG v0.1 - BẢN PHÁT HÀNH RẤT SỚM
- Downloads
- 233
- Likes
- 34
- Views
- 2,149
- Remixes
- 0
- Comments
- 0
Files 9 12.9 MB
- Tip_Panel_1777238582.stlSTL · 3.6 MB
- Nose_Cone_1777238583.stlSTL · 1.7 MB
- Covering_Template_C_1777238584.stlSTL · 14.9 KB
- Covering_Template_T_1777238585.stlSTL · 77.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #342820
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
AUW: 45.5g
Battery: 150mah 1s
Servo: 2x 1.7g rotary servo
Receiver: RX42
Tailboom: 3mmx2mmx400mm carbon tube
Wing spars: 6x 1mmx400mm carbon rod
Instructions coming soon. It should be possible to reverse engineer from the photos if you're experienced. Nose cone should be printed vase mode with 0 top/bottom. Nose and wing panels are LW-PLA, Vase mode, 0 top, 2 bottom. Wing pieces are printed on the trailing edge on the bed. You'll have to trim out the sacrificial support areas with a sharp exacto blade. Cover with tissue paper of your choice, but be wary of warping as the trailing edge is quite thin.
Print spec
- Formats
- stl
- Model files
- 9
- Total size
- 12.9 MB
- Largest file
- 5.3 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-
New -

-
New -

-


