Skip to main content
F3D
Giá treo iFi Zen Amp & DAC gắn dưới bàn 1

2 images

Dụng Cụ Tiện Ích

Giá treo iFi Zen Amp & DAC gắn dưới bàn

By Reiuiji_8421

Downloads
123
Likes
7
Views
704

Files 2 504.3 KB

  • iFi_Zen_Dac_Mount_1777228255.stepSTEP · 102.7 KB
  • iFi_Zen_Dac_Mount_1777228256.stlSTL · 401.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I wanted to mount my iFi ZEN DAC & Amplifier underneath my desk, and nothing available would do the trick! This mount fits reasonably snugly to the DAC & AMP, with the DAC on Top and the AMP below.

While the bottom is open, I have never had any issue with the Amp falling out, but I definitely recommend printing this in PLA, ABS, or PC over PETG (I did all four while testing and refining the fit & finish). While PETG holds the AMP & DAC just fine, the amount of give from the PETG's flexibility made me a little nervous.

Settings for the Mount in the Image:

  • Printer: BambuLabs X1C
  • Preset: 0.20mm Strength
  • Material: Polycarbonate Black (Though ASA, ABS, and PLA have all worked fine too)

Advice for Printing:

  • Print the Mount laying on it's back, (where the cables will attach to the DAC/AMP) rather than on the large flat part. Your Slicer will recommend the opposite, but you want the layer lines going from top to bottom to have the most strength in the direction of gravity.

You are welcome to use & remix this mount however you like, I just ask that you attribute me, or link to this page & model.

The Original Onshape Design Link

Read more Show less

Print spec

Formats
stepstl
Model files
2
Total size
504.3 KB
Largest file
401.5 KB

0 comments

See all