Skip to main content
F3D
HexCase cho RPi 5 và quạt Noctua 4pin 40mm 1

6 images

Dụng Cụ Tiện Ích

HexCase cho RPi 5 và quạt Noctua 4pin 40mm

By Carter

Downloads
113
Likes
18
Views
1,071

Files 1 6.3 MB

  • HexCase_FlatFanTop_1777213258.3mf3MF · 6.3 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Makes Wanted: Seeking information for revision/improvements.

I need to hear what is needed to make these cases work better.  Thanks!

HexCase FlatFanTop fits the Raspberry Pi 5 and Noctua 40mm 4 pin PWM fan

All HexCase RPi 5 Bases fit All Hexcase RPi 5 Tops

PiCooler best solution for cooling after some trivial testing/cost analysis.

The stands are different sizes… the tall one won't work with the shorter tops.

The Hex vented base is actually a few degrees cooler than the unvented case bottom.  Weird.

Please go to GitHub for the software and Noctua Fan PWM wiring.

https://github.com/carterm2/fancontrol-P5

Overview:

Start with the Base. assemble the Button, drop in the Raspberry Pi 5  then the Stand and the Noctua Fan, attach the GPIO pins and finally attach the Top lower edge which snaps into the Base and compresses the Stand onto the RPi PCB, creating a tight fit and does not require screws (screw boss' provided if you want to use screws).

Assembly:

Note:  Remove SD Card before assembly and disassembly to avoid damage.

Button:

Insert Button with flat edge up into Base (specific hexagonal opening…see render). 

Button will shut down and start up RPi5.

Drop in rPi5 into Base (light press down and make sure it settles into pcb support)

Place Stand over RPi5 at screw boss locations.

Drop in Noctua Fan (Manage the wires/ Dupont Connectors.)

Attach to GPIO (see Github instructions)

Top:

Install Top by carefully snapping the interference fit flange of the top cover into the base starting at the RJ45 and USB end, and gently squeeze the button end or front into the base near the lower corners.  See image provided.

Top Removal:

  There are areas cut back over the ethernet and USB ports for clearance which creates a way to assemble and remove the top simply by prying up near the USB connectors with a fingernail.  

Feedback Welcome

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
6.3 MB
Largest file
6.3 MB

0 comments

See all