Pyramid Calibration Test_0.4mm Nozzle

This Pyramid Calibration Test_ver 2 is intended to test your machine's settings and filament cooling performance. 

Test Focus:
- Bridging
- Overhangs
- Close Proximity Printing
- Stringing

Machine Settings:
- Must print at 0.20mm layer thickness.
- Infill 20%
- 3 walls minimum
- Line width should be small enough to print the letters and numbers.
- Turn off Adaptive Layers or Arachne (PrusaSlicer) during initial testing.  Tuning of the machine needs to be done with these settings off.  Once print settings show acceptable test results, you can turn on Adaptive Layers / Arachne and conduct a final test.

If you have any questions, please send us a message.

Thanks for your interest and good luck