Skip to main content
F3D
Đầu phun tưới Gardena (Gardena Watering Jet) 1

7 images

Đồ Gia Dụng

Đầu phun tưới Gardena (Gardena Watering Jet)

Remix of Vòi phun nước Gardena HF cho hệ thống tưới cao cấp By MakerTom

By MikeAnt_1361206

Downloads
607
Likes
121
Views
2,930

Files 2 9.5 MB

  • Watering_jet_1_narrower_1777180501.stlSTL · 4.4 MB
  • Watering_jet_2_wider_1777180503.stlSTL · 5.2 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

The original model by MakerTom didn't suit me at all, as I use a rain water tank pump for watering, which has a lower water pressure than has water supply line. The original jet had a throw distance about 1.5 meters with the pump. Therefore, I designed the entire jet to have a smaller flow rate with bigger throw distance and sideways dispersion. I created two variations, the second variation has an even thinner jet with more sideways dispersion. The jet is gentle on plants as it distributes a gentle stream of water.

The original nozzle was also too short and hard to get out of the hose connector, so I extended it to 65 mm.

Variants:

  • Watering_jet_1 (narrower): jet 2 x 17 mm
  • Watering_jet_2 (wider):      jet 1 x 30 mm

Print it with the jet tip on the build plate - the gardena coupling upwards. Very simple to print with any filament types. No support needed.

You need a rubber o-ring for sealing (16mm outer diameter, 2.5mm ring thickness).

If you like the model, please give it a like. ❤

Původní model autora MakerTom mi zcela nevyhovoval, neboť k zalévání používám sudové čerpadlo na dešťovou vodu, které má nižší tlak vody než je ve vodovodním řadu. Původní tryska měla s čerpadlem dosah  cca 1.5 metru. Proto jsem celou trysku navrhl tak, aby byl průtok menší s větším dosahem a rozptylem do stran. Vytvořil jsem dvě varianty, druhá varinata má ještě tenší paprsek s větším rozptylem do stran. Tryska je šetrná k rostlinám, protože distribuuje jemný proud vody.

Původní tryska také byla příliš krátká a špatně se z hadicové spojky vyndavala, prodloužil jsem ji tedy na 65 mm.

Varianty:

  • Watering_jet_1 (narrower): tryska 2 x 17 mm
  • Watering_jet_2 (wider):      tryska 1 x 30 mm

Vytiskněte model špičkou trysky na bed - spojkou Gardena nahoru. Velmi jednoduchý tisk s jakýmkoliv typem filamentu. Nejsou potřeba žádné podpory.

Pro utěsnění potřebujete pryžový o-kroužek (vnější průměr 16 mm, tloušťka kroužku 2,5 mm).

Pokud se vám model líbí, dejte mu prosím lajk.  ❤

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
9.5 MB
Largest file
5.2 MB

0 comments

See all