Skip to main content
F3D
Vỏ màn hình BTT TFT35 SPI V2.1 cho Voron 0.2 (Version 2.0) 1

3 images

Máy In 3D

Vỏ màn hình BTT TFT35 SPI V2.1 cho Voron 0.2 (Version 2.0)

By Ken226

Downloads
813
Likes
125
Views
4,232
Remixes
2

Files 9 2.6 MB

  • Right_Side_Accent2_1777171318.stpSTP · 37.7 KB
  • Left_Side_Accent2_1777171319.stpSTP · 37.6 KB
  • Bezel2_1777171320.stpSTP · 295.9 KB
  • TFT35_SPI_0.2_Mount_1777171321.stpSTP · 754.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Details

Model ID
#339929
Category
Máy In 3D
Published

Description

User Smuk3d asked me if i could create a version of the TFT35 Voron 0.2 housing that moved the viewable area of the screen to center, and allowed for a more symmetrical bezel.  

It was alot of work and required a 90ish percent redesign of the original, but I think it might just work.  

This model is still in the experimental stage, and may get some changes after he test prints and fits one.  I'll update the details here as the project continues.

The screen is held in via 4 m3x8 socket head cap screws, which go into the housing from the back and thread into the accents.  The bezel is secured over the accents with a couple drops of super glue, after glueing, the bezel/accents will be one piece.  

The bezel will probably give best results if printed using a 0.2mm layer height for the first layer, and 0.1 for all subsequent layers. All of the other parts should be printed with a .25mm first layer, and .2mm subsequent layers.

I tried to design this so that it would require minimal supports, but the honeycomb patter has some fairly long bridges.  PrusaSlicer's organic supports set to 30* worked very well for me on a similar design.

Once the design is finalized, i'll upload the .stp files so the remixers out there can make changes and design their own bezels, etc.

Read more Show less

Print spec

Formats
stlstp
Model files
9
Total size
2.6 MB
Largest file
754.6 KB

0 comments

See all