
Đèn LED gắn trên đỉnh cho máy in Voron 0.2
- Downloads
- 221
- Likes
- 49
- Views
- 1,711
- Remixes
- 0
- Comments
- 11
Files 2 1 MB
- LED_middle_piece_1766460726.stlSTL · 248.2 KB
- LED_end_piece_1766460727.stlSTL · 826.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #33969
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
For quite a while I've used the Eddie's-like clip to mount my leds under the belts.
But then I wanted to add the SlideSwipe probe to have some machine-level help with levelling the bed screws and have a bed mesh. Yes, it is mostly a gimmick, but I wanted one anyway.
So I needed a place to mount leds. I fount this mod and used it as an inspiration, as I needed to hide the cable and also wanted a better angle to lighht the printed area.
I am proud of what I designed, no visible dangling cables, if the printes is below eye level (which is usually the case) you don't see any leds and it lights up the bed better than before.
And it doesn't block the top lid, giving enough space to it on the profile to close.
Also you don't have to re-crimp your wires, as the hole is large enough to allow the XH2.54 connector to pass.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 1 MB
- Largest file
- 826.2 KB
11 comments
You may also like 12 models
See all-

-

-

-
New -
New -

-

-

-

-

-

-


