Skip to main content
F3D
Hệ Thống Sắp Xếp Carabiner (Carabiner Organization System) 1

4 images

Thể Thao & Ngoài Trời

Hệ Thống Sắp Xếp Carabiner (Carabiner Organization System)

By NLPCustoms_220761

Downloads
372
Likes
103
Views
2,730
Remixes
1

Files 3 4.9 MB

  • C.O.S._v2.3_increased_width_1777147623.stlSTL · 948.7 KB
  • climbing_rack_circular_1777147624.stlSTL · 3.1 MB
  • C.O.S_V2.2_normal_width_1777147626.stlSTL · 948.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

This is the C.O.S.

I was tired of digging around in boxes, bags, and closets to find the correct climbing gear for the day. With this I can organize my quick draws, locking gates, wire gates, and any other gear.

Increased width model has 15 holes for gear, loops for a helmet or two, and a hole at the top to hang in the closet. It's a little thicker than the normal width for extra rigidity.

Normal width model has the same hole count as the increased width model but is a little skinnier for lighter gear and decreased print time. 

The circular model is for larger amounts of gear storage. I would suggest making the Z axis (height of the print) about 1/8" - ¼" shorter, just make sure to unlock scaling when doing so.

 Use at least 25% infill

If you plan on leaving this in your car, print with ABS or another high glass transition filament.

If you are going to use it for storage and bringing it to the crag, PLA(+) will do just fine.

This is not for climbing! Do not use while climbing! This is for mobile/home organization/storage of climbing gear only.

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
4.9 MB
Largest file
3.1 MB

0 comments

See all