ToF enclosure VL53L0X - GAGGIUINO

As I didn't found an enclosure that checked all the boxes, I've designed it myself. It's a an enclosure with a print in place hinge and embedded magnets. Has the space for the soldered wires that are going to stick through the back. The pocket where are going to pass the wires is big enough for all of them(if you need). There's a notch to keep the enclosure closed. The hinge has a 0.2 gap, and the magnet pockets are meant for four 5x2 mm magnets(if you are doing the Gaggiuino build, they are the same as the magnets used for the hardware scale). The magnet pockets are 5.2x2mm as usually they are a bit thinner I didn't make the hole deeper.

Components:

• VL53L0X: link
• Magnets: link
   

As for the print settings:

• nozzle: 0,4
• speed: 40mm/s
• fan: 100%
• brim: yes
• support: no
• material: as you like(I've used clear PETG)

To add the magnets, set trough the slicer: stop the print at a layer 11 

insert the magnets, and resume the print.

That's the end result