
Adapter cho hub tiêu chuẩn trên phuộc RockShox Torque Cap
- Downloads
- 265
- Likes
- 19
- Views
- 2,847
- Remixes
- 1
- Comments
- 0
Files 1 23.7 KB
- torque_cap_fork_adapter_to_standard_hubs_1777119231.stlSTL · 23.7 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #338114
- Category
- Thể Thao & Ngoài Trời
- Published
Description
Pretty much a straight-up copy of the Newmen TC adapter because that's the simplest, most elegant solution that I've seen. In fact, the Newmen adapter is inexpensive and such a nice fix I'd suggest you just buy it from them and give them support. If that's not feasible, here's a printable version. Print it out nice and coarse (I used a 0.3mm layer height) and stick it to some double-sided tape. Cut the tape to match the shape, then clean the inside of the fork ends and pop these in place. Once they're installed, the hub drops right into place like it would on any normal fork, making installation of the axle much, much easier.
Looks like I was beaten to the punch by Christophe Witte with his model. Looks almost identical, but to be fair it's not exactly a complicated design.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 23.7 KB
- Largest file
- 23.7 KB













