Skip to main content
F3D
Trạm gốc năng lượng mặt trời Meshtastic… 1

5 images

DIY

Trạm gốc năng lượng mặt trời Meshtastic (Meshtastic Solar Base Station)

By Deli Pistačná Pistačná

Downloads
257
Likes
78
Views
3,923

Files 10 1.6 MB

  • Pole_Bracket_LMiEtool_Enclosure_1777097703.stlSTL · 372 KB
  • Enclosure_Insert_1777097704.stlSTL · 106.8 KB
  • TPU_Washer_1777097705.stlSTL · 60.8 KB
  • Solar_Panel_Bracket_25_degree_L_1777097706.stlSTL · 170.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#337241
Category
DIY
Published

Description

This is not a beginner DIY project. You will need to solder wires, drill holes, have a general understanding of electronics and also have the ability to print in ASA and TPU.

** You can purchase this already printed/assembled from my store by clicking HERE **

This design is for an off-grid weatherproof, solar powered Meshtastic node.

There is a printed insert for the ABS enclosure to house a RAK starter kit (RAK19007 & RAK4631) with BLE antenna & 2x 18650 batteries which should last over 2 weeks without sunlight/charge. There are posts to accommodate a PCM to protect the RAK and 18650 batteries from under and over voltage to prevent damage over time.

There are solar panel brackets for 25, 35 and 45 degrees. The pole bracket is slotted to allocate all 3 sizes. Print whatever solar brackets are best for capturing power based on your location. You can use an online tool to help calculate which angle is best for you based on zip code here.

You assemble the Pole Bracket & 2 matching solar panel brackets together, then U clamp the bracket to your J-Pole and then mount the solar panel and connect the JST wire to your RAK solar input.

Print Details:

  • ASA (Washers in TPU)
  • No Supports needed
  • 0.2mm layer height
  • 4 perimeters
  • 50% infill

Print List:

  • 1x Pole Bracket 
  • 1x Enclosure Insert 
  • 1x Matching Degree Set of Solar Panel Brackets (L & R)

Parts List:

UPDATE 5/5/24

I have also included a file for the Pole Bracket .stl file for another common enclosure:

AIRTAK 200x100x70mm (58mm back mounting holes): https://a.co/d/3MQEhvy

Read more Show less

Print spec

Formats
stl
Model files
10
Total size
1.6 MB
Largest file
372 KB

0 comments

See all