Chân đế dựng đứng Onewheel Pint (Onewheel Pint Stand)

I really liked shk1d29's stand, but it would not fit on my Prusa Mini. So, I combined it with TH-Props to make an ultimate combo of the two. Identical to TH-Props's stand, but with the downward slopes to center & stabilize the board from shk1d29's design.

Note - This version is for a Onewheel without float plates or cobra pad.

Link to TH-Prop's design: https://www.thingiverse.com/thing:3273259
Link to shk1d29's design: https://www.thingiverse.com/thing:3984298

Print Settings

Printer Brand:

Prusa

Printer: 

MINI

Rafts:

No

Supports: 

No

Resolution:

0.25

Infill: 

20%

Filament:

Prusament PETG Carmine Red 
 

Notes: 

* 3 lines of shell and 14 top and bottom layers.

• Also, make sure to print on it's side for best strength. *ABS is probably best, but PETG is what I had on hand and it works fine.

Category: Sport & Outdoors