Hộp mini Heltec V3 (vừa anten 13mm)

Mini case for the Heltec V3, which fits a larger antenna which none of the other mini type designs seem to.

Be aware if your print tolerances aren't the same as mine you might need to sand the side where the bottom of the screen fits in. I plan to change that at some point, I cracked a screen with my first design because I'd made it too tight. Fixed that for my printer, but just be wary, don't try forcing it. Honestly it doesn't really need that bit holding it in place so I'll likely upload a version without the screen being surrounded. 

Designed to fit a MakerFocus 1000mAh battery (26x44x9mm according to the specs). 

Requires 2 x 10mm M3 screws.