Skip to main content
F3D
IR Turret Nerf Dart (không cần dây thun) - CrunchLabs Hack… 1

2 images

DIY

IR Turret Nerf Dart (không cần dây thun) - CrunchLabs Hack Pack 001

By ahaque_263851

Downloads
109
Likes
19
Views
1,565

Files 3 2.3 MB

  • TurretBulletv2_1777027776.3mf3MF · 766.6 KB
  • TurretBullet_1777027777.3mf3MF · 704.1 KB
  • TurretBulletv3_1777027778.3mf3MF · 895.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

IR Turret Nerf Dart - Crunch Labs Hack Pack 001

Overview

This is 3D-printed replacement ammunition. No rubber band is required. The spring is 3D-printed.

3D Printing Info

  • Print Time: Approximately 30 min on Prusa MK4
  • Material: PLA/PETG
  • Supports: Yes
  • Infill: 20%
  • Layer Height: 0.2 mm
  • Perimeters: Default

Notes

  • I add a slight bend to the circle at the end of the spring (notches on the shooting end). This makes it easier to latch on.
  • I adjusted the design to minimize supports but this means the fins are shorter than the original.
  • The circle/latch is at the edge of the nerf bullet vs. the center. If it was placed at the center, it wouldn't fire straight.
  • Unsure how the spring will hold up. I'd recommend not keeping loaded on the turret when not in use to reduce wear.

Updates

  • 5/27/2024 added stronger spring to go ~3x farther (v2)
  • 5/27/2024 hollowed center of cylinder to improve aerodynamics

Read more Show less

Print spec

Formats
3mf
Model files
3
Total size
2.3 MB
Largest file
895.5 KB

0 comments

See all