
Remix: Kệ đỡ laptop có thanh nối (connecting rods)
Remix of CẬP NHẬT - Giá Đỡ Laptop Dọc / Lần 3! By BurgessG
- Downloads
- 138
- Likes
- 12
- Views
- 544
- Remixes
- 0
- Comments
- 0
Files 2 30.8 KB
- remix_laptop_stand_V2_1777005427.stlSTL · 27.4 KB
- remix_laptop_stand_connector_rod_V2_1777005429.stlSTL · 3.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #333164
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Just a couple simple connector rods, was going to glue them in but they were snug enough of a fit I didn't bother. tried to make them blend in with the regular model and not botch it up too much. Hope it saved you a few minutes.
Version 2 includes minor changes to solve the issue of connector rods not fitting if using a different infill percentage. Print without bottom and top layer and Hex infill if you wish to have the same open look.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 30.8 KB
- Largest file
- 27.4 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-
New -

-

-

-

-

-


