
CẬP NHẬT - Giá Đỡ Laptop Dọc / Lần 3!
Remix of Chân đế laptop dọc / Bản remix By BurgessG
- Downloads
- 6,306
- Likes
- 932
- Views
- 26,445
- Remixes
- 2
- Comments
- 0
Files 4 8.3 MB
- Laptop_Stand_Remix_1c_1766340162.stlSTL · 24.5 KB
- Laptop_Stand_Remix_1d_1766340162.stlSTL · 21.4 KB
- Laptop_Stand_STD_3_Holes_1766340163.stlSTL · 62.9 KB
- Laptop_Stand_STD_3_Holes_15p_PLA_MK2S_5h44m_1766340164.gcodeGCODE · 8.2 MB
Make a variant with AI
Build another version of this model.
Remix versions 2
Remix: Kệ đỡ laptop có thanh nối (connecting rods)ByKC_222651 · 04/24/2026
CẬP NHẬT - Đế dựng Laptop đứng / Phiên bản 4!ByBurgessG · 03/22/2026
Details
- Model ID
- #172394
- Category
- Đồ Gia Dụng
- Published
Description
UPDATE: I had issues printing the honeycomb when the two pieces were not aligned 100% the same. Caused an issue when I inserted the 1/8" rods (not being perpendicular) So, I added three 1/8" holes that would always print the same place, no matter how the forms were laid out on the bed. Big honeycomb, small, anything else, alignment issues, no more worries! I printed my latest using 15% infill and 3 shells. I find it a bit more ascetically pleasing.
CHECK OUT NEWER VERSION: https://www.printables.com/model/1304742-update-vertical-laptop-stand-take-4
CHECK OUT NEW ‘NEAR VERTICAL’ VERSION: https://www.printables.com/model/1444934-laptop-stand-vertical-stiletto-stand
Also, pay attention to which side you place “down” on the bed. I like to keep the “bed” side to the inside of the stand since the finish is smoother. the bed side also (ever so slightly) mushes the sharp corners of the honeycomb so the outside should contain the raw print surface.
(Also, don't forget the rubber feet!!! Bought a few dozen from B-ma-zon and they work fantastic from keep the stand from sliding around the desk when wrangle the laptop!)
This is a remix of of my remix of ChiMuFeng's vertical laptop stand. Hex fill @ 20%, 3 shells and no top/bottom. I used 1/8" metal or plastic rods to keep the stands in place and added a few rubber feet to the bottom to keep things from sliding. Looks great and works even better. The shorter front tabs make getting the laptop in/out a bit easier. The laptop only uses the first bit of the tab to lock in place the rest is otherwise just a waste of materials.
I also included a “chopped” version of the stand. No back end material so if you have a front heave laptop it will work just fine.
Like my design, how about buying me a cup of coffee?
Print spec
- Formats
- gcodestl
- Model files
- 4
- Total size
- 8.3 MB
- Largest file
- 8.2 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-
New -

-

-

-
New -

-

-


