Đèn #50 - Cityscape Puck Lamp

A free-form abstract Cityscape lamp. 

Shade: 150 mm height x 110 mm Width

Lamp:  180 mm   x 130mm width

This lamp uses a 5V Puck Led, currently a 5W - Warm White, and the one used here, see link below, uses a standard USB connector.

The base is sized exactly for this puck and there is also a snap lid which can be used to keep it in place if needed.

The base is printed using a PETG as the Led can get warm, measured with a laser and it never actually got above 47C (120 F) and the melting point on PLA is ~150 F (65 C) , but just playing it safe.

The shade is printed using a PLA.

Use  supports for the City scape shade wall. from baseplate only,  to support the wall upper regions. I used manual tree supports and provided a picture or two of where I put them.

The puck led used here: 

(The example used a 5W, 2700K, Warm White, I ordered a 3W to try, when it arrives)

https://www.aliexpress.com/item/1005006425667037.html?

The slicer settings for the shade base and snap lid

.20 mm Standard

(All standard settings and speeds, Aligned seam settings)

Filament:  Eryone Standard PETG

The slicer settings for The Shade:

Supports required. I used tree manual from build plate only on a P1P.

Filament:  Sunlu PLA+ White

.20 mm Standard  Quality 
Infill %  - 35 , Gyroid
Wall Loops - 6
 

Seam Position- Aligned