Bracket làm mát Driver cho Manta M8P CB1/CM4

Print Settings

First Layer Height: 0.25mm

Layer Height: 0.2mm

Extrusion Width: 0.4mm, forced

Infill Percentage: 40%

Infill Type: Adative Cubic, Grid, Gyroid, Honeycomb, Triangle, Cubic

Wall Count: 4

Solid Top/Bottom Layers: 4

Seam Placement: Rear

Supports: None

Hardware:

4010 Fans x 4

M3X5X4 Heatsets x 19 (16pcs for Fans, 3 for Legs)

M2.5x10mm SCHS x 4 (CB1/CM4 Heat Sink)

M3X10mm SCHS x 4 (M8P to DIN CLIPS)

Note: The screw lengths are a close guess, it would prob be better to order a kit with multiple-length screws. I will update them once I have it mounted.

Instructions

The M3 screws pass from underneath the board through the DIN clips and into the legs of the fan bracket.  You may have to drill through the DIN clips with a 3mm drill bit so the screws an pass through.

Update 6/11/24

I printed and tested the first version with my M8P v2.0 and some TMC 2240 drivers. It didn't quite clear the heatsink's on the 2240s. I extended the legs by another 4mm in v2. I will reprint this and try it with the increased leg length.