Skip to main content
F3D
QUICK-CLIP: Móc Treo Đa Dụng (General Utility Hook) 1

2 images

DIY

QUICK-CLIP: Móc Treo Đa Dụng (General Utility Hook)

By TaylorSteinf_1252185

Downloads
192
Likes
49
Views
771

Files 2 116.2 KB

  • QUICK-CLIP_-_Utility_Hook_Single_1776965433.stlSTL · 42.1 KB
  • QUICK-CLIP_-_Utility_Hook_Double_1776965434.stlSTL · 74.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

NOTE: This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"

Post-Processing Difficulty: Easy (Ready to Use from Printer)

Tools Needed: None

Introduction & Instructions:

QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a small utility hook that I designed to go with the base the base starter set (found under my profile). It is attached to and removed from the mounting system in the same way as the other module. It pairs well with the belt loop buckle, letting you free your hands by temporarily storing tools on your hip (tools, paracord loops, carabiners, etc.). I also included a double-ended version for use with two buckles on MOLLE webbing for more stability.

I printed it with 0.16mm layer lines with PLA with no supports or brims.

Hope you enjoy!

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
116.2 KB
Largest file
74.1 KB

0 comments

See all