
Khung bát Surefeed Microchip cho thú cưng – gia cố chắc hơn
Remix of Khung Chén Thức Ăn Thú Cưng Surefeed Vi Mạch - Gia Cố By sycho_1684023
- Downloads
- 182
- Likes
- 8
- Views
- 664
- Remixes
- 0
- Comments
- 0
Files 1 80.8 KB
- SureFeed_FrontFrame_reinforce_1776849696.stlSTL · 80.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #326235
- Category
- Đồ Gia Dụng
- Published
Description
This isn't a big change, and the original probably works fine. It's just that I was bothered by those snap-fit legs because the bending load is concentrated at the base. This is the worst possible location for a bending load when a flexible part is printed vertically, because the layer bonds are the weakest feature of any FDM print. The bending load should be uniformly distributed across all the layer bonds.
The engineering guidance I've found suggest that the flexing part should taper linearly in cross-section from the base to the tip. This can be done by thickening the part at the base, or making it wider, or both.
I typically don't go to 2X the area at the base. It doesn't need to be symmetric either. In this case I tapered the width of each leg, on one side, using OpenSCAD.
Print settings
- 0.2 mm layer height, 0.4 mm nozzle
- 3 perimeters
- Organic / tree supports for snap hooks
- May need mouse ears in corners to prevent them from lifting up (I printed this with a translucent material so you can barely see the mouse ears in the picture)
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 80.8 KB
- Largest file
- 80.8 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-
New -

-
New -

-


