
Cờ lê đầu vòi cho ổ cắm 1/4 inch
- Downloads
- 37
- Likes
- 4
- Views
- 243
- Remixes
- 0
- Comments
- 0
Files 2 59.8 MB
- socket-nozzle-wrench-thicker-looser_1766599212.stlSTL · 29.9 MB
- socket-nozzle-wrench-snug_1766599215.stlSTL · 29.9 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #32546
- Category
- Máy In 3D
- Published
Description
I had these sockets for MK8 and V6 nozzles laying around that I had been using and wanted to give them more grip and be easier to use. The fit is tight in the “snug” version as I had no intention of removing the socket once installed. I just printed another for my other nozzles.
The ¼" sockets I have around the house are about 12mm in diameter. The “snug” version is 12.1 mm on the inside and is a snug fit and requires pre-alignment before pressing into place. The “looser” version is 12.3 mm and should be significantly easier to install.
In-lieu of printing the looser version you can use X-Y Contour compensation (ie “-0.12” to “-0.17”) to open the print up (Orca/Bamboo slicer) or use Horizontal expansion in Cura with the same values as well.
I suggest using higher temp plastics (ABS, PC, Nylon, etc) as you will (should!) be installing your nozzles when they're hot and use 6+ walls to ensure the center peg is solid along with gyroid or cubic for strength.
Enjoy!
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 59.8 MB
- Largest file
- 29.9 MB
0 comments
You may also like 12 models
See all-

-
New -
New -

-
New -

-

-

-

-

-

-

