SPCTR G36 Handguard (VFC G36 GBBR)

Replacement handguard/rail for G36 GBBR

Tolerance for Bambu Printers so some sanding and filing may/will be required for systems with worse printing tolerance

Required Hardware

2 to 4 heat set inserts (For the Main Rail), Size for 4mm OD and M3 Threads, maximum length of 4mm

2 to 4 M3 Machine screws spec to the same size of the heated inserts

Installation and Assembly Guide

1. Press the inserts into the holes at the bottom of the Rail System (Pick to use either 2 holes diagonally or 4 holes all together Depending on how big the head on your screws are)

2. Install the Locking Bar onto the gun aligning the tabs with the tabs on the receiver

3. Slide on the rail till the front pin hole lines up 

4. Check to ensure the bottom threaded inserts line up with the holes

5. Install the Front Pin Locking the Handguard into place

6. Screw in the machine screws snugly

(Refer to images if having difficulty)