
Drybox Ikea Samla 22L
Remix of Cùng làm… Drybox v2! (Ikea Samla 22L, dùng PTFE cho spool lăn mượt) By RenMcCourtey
- Downloads
- 111
- Likes
- 14
- Views
- 1,113
- Remixes
- 0
- Comments
- 0
Files 6 3.2 MB
- Dessicant_Box_Lid_1776808349.stlSTL · 17.9 KB
- Dessicant_Box_1776808349.stlSTL · 209.5 KB
- Extended_Sides_Short_1776808350.stlSTL · 1.2 MB
- Extended_Sides_Long_1776808351.stlSTL · 1.2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #324136
- Category
- Máy In 3D
- Published
Description
I have issues on the current spool holder because the spools are tipping off the sides. I made the sides taller and also extended the front and back of the spool holders to have it centered inside the 22L Samla.
The Extended Sides have 2 different lengths. Print the longer one 2x and place it at the ends of the spool holder itself then print the shorter ones 4x.
Split the Desiccant Box and the Lid to parts to adjust the grid settings.
I printed this in Orca Slicer using my Bambu A1. Here are the settings I used for the desiccant box:
Long 2x
Short 4x
Print time and filament cost for the sides:
Dessicant Box and Lid print 2x:
Note:
In my experience, after redesigning the sides in F360, I noticed that the PTFE tubes no longer fit nicely. The holes got smaller but it might fit for you. What I did is that I pinched the PTFE tubes with needle nose pliers 'til it form an oval shape. After inserting the tube, I pinched it down again to get back on its shape. For the rods, I didn't have to reprint them so I used the original rods. Some of them fits nicely but some of them are slightly lose that I can move them with one finger. I put a piece of masking tape around the hole for the rods and it fixed it.
Print spec
- Formats
- 3mfstl
- Model files
- 6
- Total size
- 3.2 MB
- Largest file
- 1.2 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-
New -

-

-

-
New -

-

-


