Suppressor Airsoft Honeycomb ren 14MM CCW

Hey all,

Made this Suppressor while I had some down time and had nothing to do. Fits a 14MM Counter Clockwise thread that is common on most Airsoft rifles. Made this for my G&G combat machine. Adds about 155mm of extra outer barrel length so you could run an extended inner barrel through it if you wanted. as its only a 3d print depending on what filament you print it with strength will vary so don't put all your hope in it protecting a shiny new extended barrel.

Make sure you print it with the threads at the top for maximum stability on the print bed

Print settings:

• No supports needed
• 0.15mm layer height
• 195C print heat
• 0.25mm bottom layer height
• 60C bed temp
• Printed on a AnyCubic Kobra 2 NEO

Going to make a shorter model at some point and add it to this model if its wanted as this one is quite long. Please leave a comment with any issues or things I could change to the print and or the description.

Thanks all,

Ed

Update's

• (07/08/24) Just uploaded the short version of this suppressor that extends the length of the rifle by roughly 75MM for those of you who don't wont a super long rifle.