Bracket chắn phoi cho Onefinity CNC (Onefinity CNC Chip Guard Brackets)

I'm not the first one to do something like this, but I did come up with this design myself.  It's pretty straightforward.  Print one set of brackets for each side.  Mount them as shown in the pictures using #8 sheet metal screws.  Be careful not to get them too close to the rails or you will get a collision.  The bracket is designed to sit flush with the inner edge of the Y rail's foot both front and back.  Cut a piece of 1/8" hardboard 5 1/5" wide and whatever length you need for your machine variant.  The Journeyman is just under 36 7/8".  If you have a Foreman you may want an extra center piece to keep things in line.  The hardboard is flexible enough to snap in after the brackets are in place.  Just move your X axis all the way to the back first.  I also notched the hardboard where the brackets are so it would close the gap at the bottom.

I have not ran a job with these yet, but they should make for less mess under the Y rails to vacuum up.  I did run the gantry back and forth to make sure there's no clearance problems. 

I printed in PETG with 3 walls and 25%.  PLA would probably work fine as well.