
Nắp ống PTFE kèm khóa giữ filament
- Downloads
- 127
- Likes
- 15
- Views
- 586
- Remixes
- 0
- Comments
- 0
Files 1 159.8 KB
- PTFE_cap_with_filament_lock_1776777675.stlSTL · 159.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #322220
- Category
- Máy In 3D
- Published
Description
Caps a 4mm PTFE tube but retains a grip on the 1.75mm filament inside so you can keep filament contained within the drybox and attached tubing, but easily extract it when you need to connect it to the printer.
Prints quickly with no supports needed. 0.2mm layer height with 0.4mm nozzle and default slicer settings worked well for me.
To use, push this onto the end of the filament first. Cutting the filament at an angle prior to insertion gives it a better grip, but a square cut works as well. Once the filament is pushed in, you can use this to push the filament back into the PTFE tube until it's capped. This will create some slack in the drybox, but that should be no problem, and hasn't been for my drybox design. (see below)
When you're ready to use it, pull this cap out and the filament should come out with it.
Pairs perfectly with my Drybox cap filler and PTFE spool holder for drybox to make a perfect drybox that holds a single 1kg (or smaller) spool of filament. My drybox cap filler even has a provision for a small section of PTFE tube which can be used to store this when the spool is connected to a printer.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 159.8 KB
- Largest file
- 159.8 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-
New -

-

-

-


