Skip to main content
F3D
Giá đỡ bút Zebra G-301 cho hệ thống MOLLE/PALS 1

5 images

Thể Thao & Ngoài Trời

Giá đỡ bút Zebra G-301 cho hệ thống MOLLE/PALS

By MichaelDonne_1288144

Downloads
54
Likes
9
Views
620

Files 1 20.8 KB

  • Zebra_G-301-Holder_1766557825.stlSTL · 20.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I created this to keep a pen handy in my Jeep, which has seat covers with PALS (Pouch Attachment Ladder System) capability. I intentionally made it a thin as possible, so it will wiggle slightly when installed and occupies two bars in the system. Perfect for my intended use, but might be too loose for duty use on a vest or jacket. It does feature a drain hole, in case you get stuck out in the rain sans top.

The fitment of the pen is tight, but I've tried numerous actual pens (mfg'd from the late 90's to present) and all fit properly. The pen's clip is recessed in the body to avoid being snagged, living just the top exposed.

***Specifically made for the Zebra G-301 series pen. The F-301 ballpoint pen should also fit fine. It has not been tested with any other make/model.***

NOTE: It needs to be printed vertically, with the top on the bed surface (i.e. upside down). Printing right-side up results in the clip improperly printing (even with supports) about an inch in.

Printed on an Anker M5C-B using Creality CR-PETG. Settings I used (AnkerSlicer):

  • 0.40mm nozzle
  • Stock PETG Material settings
  • Easy Mode
  • 0.20mm layer height
  • 20% infill
  • Global Supports

Used ~32g of filament and took ~1hr23min to print.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
20.8 KB
Largest file
20.8 KB

0 comments

See all