Case Raspberry Pi 4 snapfit gắn quạt 60mm (screwless)

This is a later version of my 60mm fan snapfit case design and features a screwless design that allows the Pi and fan to clip into place. The whole case also snaps together nicely and comes apart by squeezing it along the longest sides.

To get the cool mesh make sure you print with 0 top or bottom layers and use a 2D infill pattern, I used the triangle infill pattern at 30-60% infill with infill line directions at 90°.

Print Settings

Supports: 

No

Resolution:

0.2

Infill: 

30-60%

Notes:

PLEASE MAKE SURE TO USE 0 TOP AND BOTTOM LAYERS TO ACHIEVE THE MESH.