Chong Chóng Gió Windmill Dễ In Dễ Lắp (Wind Spinner)

The Windmill wind spinner is easy to print and assemble, no glue or fasteners required. Prints as oriented no supports required.

Prints in 3 snap together parts and mounts on a ¼" rod. 

The blades print in one piece so requires a 230mm x 230mm bed, I haven't tested scaling. 

Spins and rotates easily to catch the wind. but it might spin a little crazy in high winds.

Designed to be as large as possible while using few parts and no fasteners. The body prints in two pieces for easier, faster printing. 

If the tolerance is too loose where the body connects to the tail you can use glue if needed.

It is large and needs to be mounted solidly and level to rotate properly.